1.Bachelor's degree in Power Electronics, Electronic Engineering or equivalent majors
2.Over 5 years ODM or JDM, RD design experience in embedded or accessory products.
3.Be familiar with X86 or embedded system design, HW validation, and FA etc..
4.Be proficient in design software ,such as: Cadence OrCAD Capture, Allegro, Altium Designer, Protel 99 and
one of SIMetrix-SIMPLIX、Saber、ADS、HFSS、Maxwell simulation software.
5.Rich experience with LCD/Touch Panel, USB, I2C, Flash, SPI, USB-Type C PD, etc..
6.Experience performing design failure mode effect analysis
7.Have capability to operate instruments, such as oscilloscope (Keysight, Tek etc), Audio Analyzer, Network
Analyzer, Hi-POT Tester, AC Source, DC Load, DC Power Analyzer, LCR Meter, Signal Generator etc.)
8.English CET-4 or above, have good English communication skill with foreign customer.
9.Willing to travel abroad and accept to travel over one month to another site for project support
10.Be familiar with EMS factory's SMT and FATP process
If you are a qualified individual with a disability, you have the right to request a reasonable accommodation if you are unable or limited in your ability to use or access https://careers.jabil.com/ site as a result of your disability. You can request a reasonable accommodation by sending an e-mail to Always_Accessible@Jabil.com or by calling 1.727.803.7515 with the nature of your request and contact information. Please do not direct any other general employment related questions to this e-mail or phone number. Please note that only those inquiries concerning a request for reasonable accommodation will be responded to from this e-mail address and/or phone number.