Descripción del Trabajo
To perform this job successfully, an individual must be able to perform each essential duty
The requirements listed below are representative of the knowledge, skill, and/or ability required.
Reasonable accommodations may be made to enable individuals with disabilities to perform the
essential functions. This job description reflects the general duties of the job, but is not a
detailed description of all duties that may be inherent to the position. Jabil may assign
reasonably related additional duties to individual employees, consistent with company policies.
Performs complex inspection of circuit boards and assemblies to ensure they conform to
required quality requirements, standards and procedures.
ESSENTIAL DUTIES AND RESPONSIBILITIES
Performs intricate visual inspection of assemblies and sub assemblies ensuring they
conform to requirements
Reads visual aids, engineering change notices, special instructions and applies
knowledge of electrical principles and IPC standards to determine acceptance or
rejection of circuit boards and assemblies
Enters standardized information into the MES system to record pass or failure of circuit
boards and assemblies
Determines cause and effect of defects and refers findings to manufacturing
Reviews and approves solutions and refers unresolved issues to QA Group Leader
and/or Quality leadership for resolution
Trains other employees on quality processes and procedures
Maintains quality records of inspection activities
Works safely at all times and complies with Environmental Health and Safety standards
and work practices along with all other work rules
Minimum two years relevant work experience or equivalent training
Advanced reading, writing and math skills (12th grade level)
Basic PC skills (opening and closing programs, keyboarding skills) and familiarity with
Able to work independently and cope with changing priorities on multiple workcells
Acquire and maintain Certified IPC Specialist Certification and Jabil QC Certification
Pass gage R&R test annually
Employee may be required to sit or stand for extended periods of time.
The employee is frequently required to walk, bend, lift, push carts and carry equipment up to 50lbs.
Required vision abilities include close vision, frequent use of computer monitor and inspection
Workstation is located on the manufacturing floor.
The noise level in the work environment is usually moderate.